Make sure that the mount kit does not interfere with any of the controls on the motorcycle.

This means that you don’t need to add a fuse yourself while performing the connection between the device and the motorcycle battery.

If you choose to attach the mount kit yourself, note that the Active Dock has a built-inįuse.

If you are unsure about attaching the mount kit yourself, ask a professional to fit it for.

When you are attaching the mount kit to your motorcycle, TomTom Rider uses a GPS receiver to locate your current position.Īttach the RAM™ mount kit to your motorcycle as shown on the Installation Poster, then Your Rider does not transmit your location, so others cannot use it to track you while you

In the future, your position will be found much faster, normally within a The first time you start your Rider, it can take a few minutes for the device to find yourĬurrent position. That you are in an open place without tall buildings or trees around you. Your TomTom Rider must be outside to be able to locate your current position. You will use the touchscreen for everything you do with your TomTom Not into a USB hub or USB port on a keyboard or monitor.įirst, you have to answer a few questions to set up your device.

Note: You should plug the USB connector directly into a USB port on your computer and The battery in your TomTom Rider navigation device charges when you connect it to the Switch off your TomTom Rider, press and hold the On/Off button for 2 seconds.īefore you use your Rider for the first time, it’s a good idea to charge it fully. The first time you switch on your TomTom Rider, it may take up to 20 seconds to start.

Press and hold the On/Off button for 2 seconds, or until your TomTom Rider starts.

Tomtom one crack anleitung